Altera Low Latency Ethernet 10G MAC Manuel d'utilisateur Page 65

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 109
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 64
RX Configuration and Status Registers
Table 4-9: RX Configuration and Status Registers
Word
Offset
Register Name Description Access HW Reset
Value
0x00A0 rx_transfer_control
Bit 0—RX path enable.
0: Enables the RX path.
1: Disables the RX path. The MAC IP
core drops all incoming frames.
Bits 31:1—reserved.
A change of value in this register takes
effect at a packet boundary. Any transfer in
progress is not affected.
RW 0x0
0x00A2 rx_transfer_status
The MAC sets the following bits to indicate
the status of the RX datapath.
Bits 7:0—reserved.
Bit 8: RX datapath status.
0: The RX datapath is idle.
1: An RX data transfer is in progress.
Bits 11:9—reserved.
Bit 12: RX datapath reset status.
0: The RX datapath is not in reset.
1: The RX datapath is in reset.
RO
0x0
0x00A4 rx_padcrc_control
Bits [1:0]—Padding and CRC removal
on receive.
00: Retains the padding bytes and CRC
field, and forwards them to the client.
01: Retains only the padding bytes. The
MAC IP core removes the CRC field
before it forwards the RX frame to the
client.
11: Removes the padding bytes and CRC
field before the RX frame is forwarded to
the client.
10: Reserved.
Bits 31:2—reserved.
Configure this register before you enable
the MAC IP core for operations.
RW
0x1
UG-01144
2014.12.15
RX Configuration and Status Registers
4-13
Configuration Registers for LL Ethernet 10G MAC
Altera Corporation
Send Feedback
Vue de la page 64
1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 108 109

Commentaires sur ces manuels

Pas de commentaire