Altera High-Speed Development Kit, Stratix GX Edition Manuel d'utilisateur Page 74

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 140
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 73
5–30 Quartus II Version 3.0 Altera Corporation
Nios-Based Tests High-Speed Development Kit, Stratix GX Edition User Guide
9. Exit the terminal window by pressing the Ctrl + C keys.
10. Start the test by typing nr st.srec r. This command initializes
the on-board MAC/PHY chip on the 10/100-Mbit Ethernet
network-interface card. Observe the shell for the proper response.
See Figure 5–23.
Figure 5–23. 10/100 Ethernet Network-Interface Card Test Results
###################################
NOTE: w/ethernet cable plugged in (below)
[SOPC Builder]$ nr hello_plugs.srec
nios-run: Ready to download hello_plugs.srec over COM1: at 115200 bps
nios-run: Downloading...........................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
...
nios-run: Terminal mode (Control-C exits)
-----------------------------------------
Reinitializing...
[lan91c111] nr_lan91c111_reset: chip id = SMC91C11xFD
[lan91c111] r_lan91c111_detect_phy: found lan83C183 (lan91C111 internal)
[lan91c111] r_lan91c111_init_phy: 10bt
[lan91c111] r_lan91c111_init_phy: half duplex
[accepting offer] from server 137.57.185.13, for ip address 137.57.185.196, leas
e time 446301
[ ignoring offer] from server 137.57.185.13, for ip address 137.57.185.196, leas
e time 446301
[lan91c111] nr_lan91c111_reset: chip id = SMC91C11xFD
[lan91c111] r_lan91c111_detect_phy: found lan83C183 (lan91C111 internal)
[lan91c111] r_lan91c111_init_phy: 10bt
[lan91c111] r_lan91c111_init_phy: half duplex
[plugs] +-----------------------
[plugs] | initialized adapter lan91c111 at 0x00c204a0, 137.57.185.196
[lan91c111] nr_lan91c111_reset: chip id = SMC91C11xFD
[lan91c111] r_lan91c111_detect_phy: found lan83C183 (lan91C111 internal)
[lan91c111] r_lan91c111_init_phy: 10bt
[lan91c111] r_lan91c111_init_phy: half duplex
Vue de la page 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 139 140

Commentaires sur ces manuels

Pas de commentaire