Altera High-Speed Development Kit, Stratix GX Edition Manuel d'utilisateur télécharger pdf (Page 73)

Altera Corporation Quartus II Version 3.0 5–29

Perform the Production Diagnostic Tests Nios-Based Tests

Checking Written Data:

Test Done: Goodbye...

#77153008

lan16_all_flash4_pcb_revb

16. Press reset (Stratix_PB_0) to stop the test.

17. Press Ctrl + C in the shell to exit the test program.

18. If this test passes, write the word “PASS” in the column under

Stratix in the row Stratix Nios On-Board Flash and Nios EPC16

Flash in the worksheet.

10/100 Ethernet Network-Interface Card I/O Interface (Stratix

Nios PROTO1 IO)

For this test, perform the following steps.

1. Change the programming file for the Stratix device to the

st_1s40.sof file. Wait until the checksum field is updated.

2. Turn on the Program/Configure option for the Stratix device.

3. Click Start. When configuration is complete, the S_CONF_DONE

LED illuminates.

4. Choose Programs > Altera > SOPC Builder <version> > SOPC

Builder SDK Shell (Windows Start menu).

5. Change to the Nios SOFs directory by typing the following

command:

cd /Stratix_GX_kit/Test_designs/Nios_test_designs/

Nios_sofs r

6. Type nr -t r to open a terminal window that connects to COM 1.

7. Press the Enter key twice in the terminal window. You should be at

a Nios prompt.

8. Confirm that you are connected to the Nios processor running on

the board by pressing the Enter key a few times in the terminal

window to display the processor’s memory contents.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 139 140

Pas de commentaire

Altera High-Speed Development Kit, Stratix GX Edition Manuel d'utilisateur Page 73