Altera High-Speed Development Kit, Stratix GX Edition Manuel d'utilisateur télécharger pdf (Page 58)

5–14 Quartus II Version 3.0 Altera Corporation

Perform the Standard Tests High-Speed Development Kit, Stratix GX Edition User Guide

Source Synchronous HM-Zd Interface (Stratix GX HM-Zd SPI 4.2)

For this test, perform the following steps in the Programmer.

1. Change the programming file for the Stratix GX device to

GX40_SS_HMZd.sof. Wait until the checksum field is updated.

2. Turn on the Program/Configure option for the Stratix GX device.

Figure 5–17 shows the Programmer after you have done these steps.

Figure 5–17. Quartus II Programmer for the Source-Synchronous HM-ZdTest

3. Click Start. When configuration is complete, the GX_CONF_DONE

(D7) LED illuminates.

4. Press the reset pushbutton switch (GX_CLR).

5. Press the start pushbutton switch (Stratix_GX_PB_0). Several LEDs

illuminate.

● LED0 is the high-speed data and control signal match LED. If it

illuminates, the test is successful.

● LED1 indicates that the GX device has received the data.

● LED2 indicates a per channel match. This LED is used for the per

channel feature.

● LED3 indicates that the test has started.

● LED4 is the match LED for the low-speed control signals.

● LED5 is the error indicator.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 139 140

Pas de commentaire

Altera High-Speed Development Kit, Stratix GX Edition Manuel d'utilisateur Page 58