Altera High-Speed Development Kit, Stratix GX Edition Manuel d'utilisateur télécharger pdf (Page 60)

5–16 Quartus II Version 3.0 Altera Corporation

Perform the Standard Tests High-Speed Development Kit, Stratix GX Edition User Guide

Figure 5–18. Quartus II Programmer for the Source-Synchronous DPA Test

4. Click Start. When configuration is complete, the GX_CONF_DONE

(D7) LED illuminates.

5. Press the reset pushbutton switch (GX_CLR) to initialize the design.

The GX_DEV_CLR LED illuminates.

6. Press the start pushbutton switch (GX PB0). Several LEDs

illuminate.

● LED0 is the match LED; it illuminates if the test is successful.

LED1 indicates that the test is running.

● LED2 indicates that the device has received the data through the

cables.

● LED3 is the per channel match. This LED is used for the per

channel feature.

● LED4 is turned off.

● LED5 is the error signal.

7. Press the stop pushbutton switch (Stratix_GX_PB1) to stop the

device from transmitting.

8. Press the reset pushbutton switch (GX_CLR).

9. Press the start pushbutton switch (Stratix_GX_PB_0).

10. Inject an error by pressing Stratix_GX_PB_2 (S4) once. The number

01 displays on the Stratix GX 7-segment display (D9) and Stratix GX

LED5 illuminates.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 139 140

Pas de commentaire

Altera High-Speed Development Kit, Stratix GX Edition Manuel d'utilisateur Page 60