Altera High-Speed Development Kit, Stratix GX Edition Manuel d'utilisateur télécharger pdf (Page 37)

Altera Corporation Quartus II Version 3.0 4–9

Run the Preloaded Diagnostic Tests Stratix GX HM-Zd SPI-4.2 Loopback

Figure 4–5. Install the HM-Zd SPI-4.2 Loopback Cards

4. Supply power to the board.

5. Confirm that the Stratix GX device has finished configuration (the

GX_CONF_DONE (D7) LED illuminates).

Run the Stratix GX HM-Zd SPI-4.2 Loopback Test

Perform the following steps to run the test.

1. Setthe Stratix GX dipswitch 5 to 1 (up position).

2. Press the reset pushbutton switch (GX_CLR).

3. Press the start pushbutton switch (Stratix_GX_PB_0). Several LEDs

illuminate.

● LED0 is the high-speed data match LED. If it illuminates, the test

is successful.

● LED1 indicates that the GX device has received the data.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 139 140

Pas de commentaire

Altera High-Speed Development Kit, Stratix GX Edition Manuel d'utilisateur Page 37