Altera DDR Timing Wizard Manuel d'utilisateur Page 18

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 92
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 17
2–6 Altera Corporation
DDR Timing Wizard User Guide November 2007
Entering and Editing Inputs to the DTW
Figure 2–2. Launching the DDR Timing Wizard
3. Click Run.
1 You can also launch the DTW from the command line with
the following command:
<quartus_ii_installation_directory>/bin/quartus_sh --dtw
Entering and
Editing Inputs to
the DTW
If you use the Altera legacy controller MegaWizard as a starting point for
your memory interfaces, follow the import flow described below to enter
and edit inputs to the DTW. The legacy controller MegaWizard is the
recommended tool, and simplifies entry of the essential design
requirements. If you have an interface that is not supported by the legacy
controller MegaWizard , refer to Manual Flow for Other External
Memory Interfaces or Source Synchronous Systems” on page 2–14.
1 The screen captures of the DTW pages shown in this section are
from the Legacy_PHY.qar design that is downloadable with
AN328: Interfacing DDR2 SDRAM in Stratix II, Stratix II GX, and
Arria GX Devices.
Vue de la page 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 91 92

Commentaires sur ces manuels

Pas de commentaire