Altera Stratix GX Transceiver Manuel d'utilisateur Page 302

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 318
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 301
B–6 Altera Corporation
Stratix GX Transceiver User Guide January 2005
Output Ports
rx_clkout[]
No Output clock from the
transceiver block
receiver channel.
Output port [NUMBER_OF_CHANNELS -
1..0] wide. If you set the
USE_RATE_MATCH_FIFO parameter to
ON and the CLK_OUT_MODE_REFERENCE
parameter is set to
ON, the rx_clkout[]
port is the PLL reference clock with the
period
PLL_INCLOCK_PERIOD /
DATA_RATE) * CHANNEL_WIDTH. If you
set the
USE_RATE_MATCH_FIFO
parameter to
ON and the
CLK_OUT_MODE_REFERENCE parameter
is set to
OFF, the rx_clkout[] port is the
clock output of the PLL. If you set the
USE_RATE_MATCH_FIFO parameter is
OFF, the value of the rx_clkout[] port
is the same as the value of the
rx_recovclockout[] port. If you set
the
USE_DOUBLE_DATA_MODE
parameter
OFF, the clock period must be
doubled, or the clock frequency must be
halved.
rx_locked[]
No Gives the status of the
transceiver block
receiver channel atom.
Output port [NUMBER_OF_CHANNELS -
1..0] wide. Indicates that the transceiver
block receiver PLL is locked to the
reference input clock (active low). When the
transceiver block receiver PLL is locked,
this signal is GND. When the transceiver
block receiver PLL is out of lock, this signal
is VCC. The signal achieves lock status
within several clock cycles in simulation.
This does not necessarily reflect the real
lock time in hardware, which can take
thousands of cycles for some settings.
rx_channelaligned[]
Yes Channel alignment
status for the
transceiver block
receiver channels.
Output port [NUMBER_OF_QUADS - 1..0]
wide. If the
PROTOCOL parameter is set to
XAUI, the rx_channelaligned[] port
must be connected.
Table B–2. Output Ports (Part 2 of 4)
Port Name Required Description Comments
Vue de la page 301
1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 317 318

Commentaires sur ces manuels

Pas de commentaire