Altera Stratix GX Transceiver Manuel d'utilisateur Page 205

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 318
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 204
Altera Corporation 8–1
January 2005
8. Stratix GX Built-In Self Test
(BIST)
Introduction
Each Stratix
®
GX channel in the gigabit transceiver block contains
embedded built-in self test (BIST) circuitry, which is available for quick
device verification. The BIST circuitry consists of a data generator that
resides in the transmitter channel and a verifier that resides in the receiver
channel. Figure 8–1 shows a simplified block diagram of the BIST
circuitry.
Figure 8–1. Image of Stratix GX Built-In Self Test
Notes to Figure 8–1:
(1) rx_slpbk[] is required in PRBS and incremental BIST modes.
(2) rx_bisterr[] and rx_bistdone[] are only available in PRBS and incremental
BIST modes.
The BIST data generator is configured to generate pseudo-random binary
sequence (PRBS), incremental, high-frequency, low-frequency, or mixed-
frequency patterns. The BIST verifier supports only the PRBS and
Incremental modes. The remaining BIST modes are intended for quick
evaluations of the transmitters. The Quartus
®
II software simulation
models do not support the PRBS patterns generated in the BIST circuit.
Figure 8–2 shows the BIST modes.
Built-In Self Test
(BIST)
txdigitalreset[]
rxdigitalreset[]
rx_bisterr[]2
rx_bistdone[]2
tx_out[]
rx_slpbk[]1
inclk[]
Vue de la page 204
1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 317 318

Commentaires sur ces manuels

Pas de commentaire