
2–30 Chapter 2: Board Components
General User Interfaces
Stratix III 3SL150 Development Board May 2013 Altera Corporation
Reference Manual
Table 2–24 lists the user-defined DIP switch component reference and manufacturing
information.
User-Defined LEDs
The board includes general and HSMC user-defined LEDs. This section discusses all
user-defined LEDs. For information about board specific or status LEDs, refer to
“Status Elements” on page 2–19.
General User-Defined LEDs
Board references D20 through D27 are eight user LEDs, which allow status and
debugging signals to be driven to LEDs from the FPGA designs loaded into the
Stratix III device. The LEDs illuminate when a logic 0 is driven, and do not illuminate
when a logic 1 is driven. There is no board-specific function for these LEDs.
Table 2–25 lists the general user LED reference number, schematic signal name, and
corresponding Stratix III device pin number.
SW5 pin 7 User-defined DIP switch pin 7
USER_DIPSW6
1.8 V L19
SW5 pin 8 User-defined DIP switch pin 8
USER_DIPSW7
1.8 V L20
Table 2–23. User-Defined DIP Switch Pin-Out (SW5) (Part 2 of 2)
Board Reference Description
Schematic
Signal Name
I/O Standard
Stratix III
Device
Pin Number
Table 2–24. User-Defined DIP Switch Component Reference and Manufacturing Information
Board Reference Description Manufacturer
Manufacturing
Part Number
Manufacturer
Website
SW5 8-position rocker DIP switch Grayhill Corporation 76SB08ST www.grayhill.com
Table 2–25. LED Reference Number, Schematic Signal Name, and Stratix III Device Pin Number
LED Board
Reference
Description
Schematic
Signal Name
I/O
Standard
Stratix III Device
Pin Number
D27 User-defined LED
USER_LED0
1.8 V F21
D26 User-defined LED
USER_LED1
1.8 V C23
D25 User-defined LED
USER_LED2
1.8 V B23
D24 User-defined LED
USER_LED3
1.8 V A23
D23 User-defined LED
USER_LED4
1.8 V D19
D22 User-defined LED
USER_LED5
1.8 V C19
D21 User-defined LED
USER_LED6
1.8 V F19
D20 User-defined LED
USER_LED7
1.8 V E19
Commentaires sur ces manuels