Altera 40-Gbps Ethernet MAC and PHY MegaCore Function Manuel d'utilisateur Page 179
- Page / 199
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Word
Addr
Bit R/W Name Description
• [4:0]: Selector
• [9:5]: Echoed nonce which are set by the state machine
• [12:10]: Pause bits
• [13]: Remote Fault bit
• [14]: ACK which is controlled by the SM
• [15]: Next page bit
Bit 49, the PRBS bit, is generated by the Auto-Negotiation TX
state machine.
21:16 RW Override AN_
TECH[5:0]
Specifies an AN_TECH value to override. The following
encodings are defined:
• [16]: AN_TECH[0] = 1000Base-KX
• [17]: AN_TECH[1] = XAUI
• [18]: AN_TECH[2] = 10GBASE-KR
• [19]: AN_TECH[3] = 40G
• [20]: AN_TECH[4] = CR-4
• [21]: AN_TECH[5] = 100G
You must write 0xC0[5] to 1'b1 for these overrides to take
effect.
25:24
RW Override AN_
FEC[1:0]
Specifies an AN_FEC value to override. The following
encodings are defined:
• [24]: AN_ FEC [0] = Capability
• [25]: AN_ FEC [1] = Request
You must write 0xC0[5] to 1'b1 for these overrides to take
effect.
30:28 RW Override AN_
PAUSE[2:0]
Specifies an AN_PAUSE value to override. The following
encodings are defined:
• [28]: AN_PAUSE[0] = Pause Ability
• [29]: AN_PAUSE[1] = Asymmetric Direction
• [30]: AN_PAUSE[2] = Reserved
Need to set 0xC0 bit-5 to take effect.
0xC4 31:0 RW User base page
high
The Auto-Negotiation TX state machine uses these bits if the
Auto-Negotiation base pages ctrl bit is set. The following bits
are defined:
• [4:0]: Correspond to bits 20:16 which are TX nonce bits.
• [29:5]: Correspond to page bit 45:21 which are the
technology ability.
Bit 49, the PRBS bit, is generated by the Auto-Negotiation TX
state machine.
C-6
10GBASE-KR PHY Register Definitions
UG-01088
2014.12.15
Altera Corporation
10GBASE-KR Registers
Send Feedback
- MegaCore Function User Guide 1
- Contents 2
- PHY MegaCore Function 4
- 40- or 100-GbE MAC 5
- Device Family Support 7
- IP Core Verification 9
- Simulation Environment 10
- Hardware Testing 10
- Module ALMs Logic Registers 11
- Release Information 21
- Item Description 22
- Getting Started 23
- OpenCore Plus IP Evaluation 24
- IP Core Parameters 25
- Parameter Type Range Default 28
- Parameter Description 28
- Simulating the IP Core 32
- Pin Assignments 33
- 40-100GbE IP Core Testbenches 36
- Testbenches with Adapters 37
- File Names Description 38
- Testbenches without Adapters 40
- Initializing the IP Core 46
- High Level System Overview 49
- 40-100GbE IP Core TX Datapath 50
- Address Insertion 51
- Length/Type Field Processing 52
- Frame Padding 52
- Client Interface 53
- Data Bus Width (Bits) 53
- 40GbE IP Core 100GbE IP Core 53
- 40-100GbE IP Core RX Datapath 67
- RX CRC Forwarding 69
- Address Checking 71
- Inter‑Packet Gap 71
- Pause Ignore 71
- Name Direction Description 73
- 100GbE CAUI–4 PHY 79
- Pause Transmission Logic 82
- Statistics Counters Interface 86
- Name Signal 87
- Direction 87
- Description 87
- Control Data Description 89
- Lane to Lane Deskew Interface 90
- MII Control 91
- MII Data 91
- PCS BER Monitor 92
- Control and Status Interface 98
- Signal Name Description 100
- UG-01088 101
- 2014.12.15 101
- Related Information 102
- Send Feedback 103
- Altera Corporation 103
- Functional Description 103
- Software Interface: Registers 123
- Register Description 124
- 40-100GbE IP Core Registers 126
- Address Name Applicable 128
- Device(s) 128
- Bit Description HW Reset 128
- Bits Description HW Reset 130
- Lock Status Registers 131
- Bit Error Flag Registers 133
- PCS Hardware Error Register 134
- BER Monitor Register 134
- Test Mode Register 135
- Test Pattern Counter Register 135
- MAC and PHY Reset Registers 136
- PCS‑VLANE Registers 138
- PRBS Registers 139
- 40GBASE-KR4 Registers 139
- Pause Registers 149
- MAC Hardware Error Register 151
- CRC Configuration Register 152
- MAC Address Registers 154
- Statistics Registers 155
- PMD Registers 163
- MDIO Registers 164
- Ethernet Glossary 166
- Term Definition 167
- Subscribe 169
- Core v12.0 Release 173
- 10GBASE-KR Registers 174
- Bit R/W Name Description 175
- Additional Information 190
- Date ACDS 191
- at offset 0x127), described 193
- How to Contact Altera 198
- Typographic Conventions 198
- Visual Cue Meaning 199
Produits connexes et manuels pour Instruments de mesure Altera 40-Gbps Ethernet MAC and PHY MegaCore Function
(39 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels