Altera PHY IP Core Guide de l'utilisateur Page 28
- Page / 176
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
2–12 Chapter 2: Getting Started
HardCopy Device Migration Guidelines
External Memory Interface Handbook Volume 3 December 2010 Altera Corporation
Section II. DDR3 SDRAM Controller with ALTMEMPHY IP User Guide
As shown in Table 2–9, the Quartus II Fitter restricts the VCO operating range to
1212.1 MHz, rather than the 1515 MHz of Table 2–8. This restriction produces a phase
step mismatch between the PLL generated by the Quartus II Fitter and the PHY
sequencer setup written in the RTL. Because the calibration process expects a common
step size, the resulting design does not function properly in either the prototype
FPGA or in the HardCopy device.
If you choose to prototype in a slower speed grade FPGA (C4) and target a HardCopy
device, you must generate the ALTMEMPHY IP for the mid-speed grade FPGA to
ensure that proper values are chosen for both the FPGA and HardCopy devices—this
applies whether a performance improvement is desired or not.
f For information about HardCopy issues such as vertical I/O overhang, PLLs adjacent
to I/Os, performance improvement, and timing closure, refer to HardCopy III Device
I/O Features in the HardCopy III Device Handbook, Volume 1, and HardCopy IV Device
I/O Features in the HardCopy IV Device Handbook, Volume 1.
- User Guide 1
- Contents 3
- Chapter 8. Latency 5
- Chapter 9. Timing Diagrams 5
- 1. About This IP 7
- Release Information 8
- Device Family Support 8
- 1–4 Chapter 1: About This IP 10
- Features 10
- ALTMEMPHY Megafunction 11
- Note to Table 1–4: 12
- Note to Table 1–5: 12
- High-Performance Controller 13
- System Requirements 14
- Installation and Licensing 14
- Free Evaluation 15
- 1–10 Chapter 1: About This IP 16
- 2. Getting Started 17
- Specifying Parameters 18
- SOPC Builder Flow 19
- Generated Files 22
- 3. Parameter Settings 29
- Memory Settings 30
- ALTMEMPHY Parameter Settings 31
- Note to Table 3–3: 34
- Note to Table 3–5: 38
- PHY Settings 39
- Board Settings 41
- Controller Settings 42
- 4. Compiling and Simulating 47
- Compiling the Design 48
- Simulating the Design 50
- Calibration 55
- DDR3 SDRAM Without Leveling 55
- Step 6: Postamble 57
- Step 7: Prepare for User Mode 57
- DDR3 SDRAM With Leveling 59
- Step 2: Write Leveling 62
- Address and Command Datapath 63
- ° ), or the inverted 64
- Clock and Reset Management 65
- Clock Management 65
- Note to Table 5–1: 67
- Reset Management 69
- Read Datapath 70
- Write Datapath 74
- ALTMEMPHY Signals 75
- Notes to Table 5–3: 77
- Note to Table 5–3: 79
- Notes to Table 5–5: 82
- PHY-to-Controller Interfaces 83
- Notes to Figure 5–17: 86
- Notes to Figure 5–18: 87
- Notes to Figure 5–19: 88
- Notes to Figure 5–20: 89
- Preliminary Steps 90
- Design Considerations 90
- Clocks and Resets 90
- Using a Custom Controller 91
- 6. Functional Description— 95
- Command FIFO Buffer 96
- PHY Interface Logic 98
- Control Logic 99
- Figure 6–3. ECC Block Diagram 100
- Block Description 101
- Interrupts 102
- Partial Writes 102
- Partial Bursts 103
- ECC Latency 103
- ECC Registers 104
- ECC Register Bits 106
- Example Top-Level File 108
- Example Driver 109
- Top-level Signals Description 110
- or vhd file 111
- Note to Table 6–14: 114
- 7. Functional Description— 117
- Write Data FIFO Buffer 120
- Command Queue 120
- Bank Management Logic 120
- Timer Logic 121
- Command-Issuing State Machine 121
- ODT Generation Logic 122
- User-Refresh Commands 122
- Multi-Cast Write 122
- Low-Power Mode Logic 123
- Error Correction Coding (ECC) 123
- Notes to Table 7–7: 133
- Register Maps Description 134
- ALTMEMPHY Register Map 135
- Controller Register Map 137
- 8. Latency 143
- 8–2 Chapter 8: Latency 144
- Chapter 8: Latency 8–3 145
- 8–4 Chapter 8: Latency 146
- 9. Timing Diagrams 147
- Auto-Precharge 148
- [1] [2] [3] 148
- User Refresh 149
- Initialization Timing 156
- Calibration Timing 158
- AABBCCDD AABBCCDD AABBCCDD 162
- EEFF0011 EEFF0011 EEFF0011 162
- [1] [3] [4][2] 166
- Half-Rate Read With Gaps 168
- Half-Rate Write With Gaps 169
- [2][1] [5] [4] [6][3] 170
- [12][6][7][10] [11] 172
- Additional Information 175
- Typographic Conventions 176
Origin Storage ENSED-DELL-250/5-F13 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Interne Festplatten Origin Storage ENSED-DELL-250/5-F13.
Wir stellen 1 PDF-Handbücher Origin Storage ENSED-DELL-250/5-F13 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Datenblatt
Origin storage ENSED-DELL-250/5-F13 Datenblatt (1 Seiten)
Marke: Origin-storage | Kategorie: Internal hard drives | Größe: 0.07 MB |
Inhaltsverzeichnis
Weitere Produkte und Handbücher für Interne Festplatten Origin Storage
| Modelle | Dokumententyp |
|---|---|
| DELL-160S/5-NB44 |
Datenblatt
Origin Storage 160GB SATA 5400RPM,
1 Seiten
|
| FUJ-250SATA/7-S2 |
Datenblatt
Origin Storage 250GB 7.2K SATA,
1 Seiten
|
| HP-320S/5-NB28 |
Datenblatt
Origin Storage 320GB,
1 Seiten
|
| DELL-1500SATA/7-S11 |
Datenblatt
Origin Storage Dell PowerEdge R/T x10 Series,
1 Seiten
|
| DELL-320S/5-NB29 |
Datenblatt
Origin Storage Inspiron 640M drive,
1 Seiten
|
| DELL-2000SATA/7-S11 |
Datenblatt
Origin Storage Dell PowerEdge R/T x10 Series,
1 Seiten
|
| TOS-120/5-NB22 |
Datenblatt
Origin Storage 120GB 5400RPM Notebook Drive,
1 Seiten
|
| TOS-80/5-NB31 |
Datenblatt
Origin Storage 80GB 5400RPM Notebook Drive,
1 Seiten
|
| DELL-500S/5-NB37 |
Datenblatt
Origin Storage 500GB,
1 Seiten
|
| ENFIP-DELL-500/NB33 |
Datenblatt
Origin Storage 500GB 7200RPM Enigma FIPS Notebook Drive,
1 Seiten
|
| DELL-320S/5-NB26 |
Datenblatt
Origin Storage Dell Latitude D530 drive,
1 Seiten
|
| CPQ-300SAS/15-S5 |
Datenblatt
Origin Storage 300GB 15K SAS Hot Swap Server Drive,
1 Seiten
|
| DELL-160S/5-NB39 |
Datenblatt
Origin Storage 160GB,
1 Seiten
|
| DELL-500S/5-NB40 |
Datenblatt
Origin Storage 500GB,
1 Seiten
|
| DELL-600SAS/15-S11 |
Datenblatt
Origin Storage Dell PowerEdge R/T x10 Series,
1 Seiten
|
| TOS-80/5-NB32 |
Datenblatt
Origin Storage 80GB 5400RPM Notebook Drive,
1 Seiten
|
| DELL-320S/5-NB36 |
Datenblatt
Origin Storage 320GB,
1 Seiten
|
| DELL-320S/5-NB39 |
Datenblatt
Origin Storage 320GB,
1 Seiten
|
| TOS-120/5-NB24 |
Datenblatt
Origin Storage 120GB 5400RPM Notebook Drive,
1 Seiten
|
| IBM-36SAS/15-S4 |
Datenblatt
Origin Storage 36GB 15K SAS Hot Swap Server Drive,
1 Seiten
|
© 2020, manymanuals.fr. Tous droits réservés | 0.084 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels