
15–2 Chapter 15: Introduction to ALTMEMPHY IP
Release Information
External Memory Interface Handbook November 2012 Altera Corporation
Volume 3: Reference Material
The example top-level file is a fully-functional design that you can simulate,
synthesize, and use in hardware. The example driver is a self-test module that issues
read and write commands to the controller and checks the read data to produce the
pass or fail, and test complete signals.
The ALTMEMPHY megafunction creates the datapath between the memory device
and the memory controller. The megafunction is available as a stand-alone product or
can be used in conjunction with the Altera high-performance memory controller.
When using the ALTMEMPHY megafunction as a stand-alone product, use with
either custom or third-party controllers.
1 For new designs, Altera recommends using a UniPHY-based external memory
interface, such as the DDR2 and DDR3 SDRAM controllers with UniPHY, QDR II and
QDR II+ SRAM controllers with UniPHY, or RLDRAM II controller with UniPHY.
Release Information
Table 15–1 provides information about this release of the DDR3 SDRAM Controller
with ALTMEMPHY IP.
Altera verifies that the current version of the Quartus
®
II software compiles the
previous version of each MegaCore function. The MegaCore IP Library Release Notes
and Errata report any exceptions to this verification. Altera does not verify
compilation with MegaCore function versions older than one release. For information
about issues on the DDR, DDR2, or DDR3 SDRAM high-performance controller and
the ALTMEMPHY megafunction in a particular Quartus II version, refer to the
Quartus II Software Release Notes.
Table 15–1. Release Information
Item Description
Version 11.1
Release Date November 2011
Ordering Codes
IP-SDRAM/HPDDR (DDR SDRAM HPC)
IP-SDRAM/HPDDR2 (DDR2 SDRAM HPC)
IP-HPMCII (HPC II)
Product IDs
00BE (DDR SDRAM)
00BF (DDR2 SDRAM)
00C2 (DDR3 SDRAM)
00CO (ALTMEMPHY Megafunction)
Vendor ID 6AF7
Commentaires sur ces manuels