Altera Cyclone III FPGA Guide de l'utilisateur télécharger pdf (Page 15)

September 2010 Altera Corporation Cyclone III FPGA Development Kit User Guide

4. Development Board Setup

Introduction

The instructions in this chapter explain how to install the development board and

configure the FPGA.

Requirements

Before starting the installation, verify that you have complied with the conditions

described in “Hardware Requirements” on page 2–2 and have completed the

following requirements:

■ Quartus II software installed on the host computer

■ USB-Blaster driver software installed on the host computer.

1 The Cyclone III development board includes integrated USB-Blaster circuitry for

FPGA programming. Host computer and development board cannot communicate

without the USB-Blaster driver software installed. For installation information, refer

to “Installing the USB-Blaster Driver” on page 3–3.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Pas de commentaire

Altera Cyclone III FPGA Guide de l'utilisateur Page 15