Altera Cyclone III FPGA Guide de l'utilisateur Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 48
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
September 2010 Altera Corporation Cyclone III FPGA Development Kit User Guide
3. Software Installation
Introduction
This section describes the following procedures:
“Installing the Cyclone III Development Kit”
“Installing the Quartus II Web Edition Software” on page 3–2
“Installing the USB-Blaster Driver” on page 3–3
1 Before starting the installation, verify that you have complied with the conditions
described in “Software Requirements” on page 2–2.
Installing the Cyclone III Development Kit
The license-free Cyclone III Development Kit installer includes all the documentation
and design examples for the kit.
To install the Cyclone III Development Kit, follow these steps:
1. Download the Cyclone III Development Kit installer from the Cyclone III FPGA
Development Kit page of the Altera website. Alternatively, you can request a
development kit DVD from the Development Kits, Daughter Cards &
Programming Hardware page of the Altera website.
2. Follow the on-screen instructions to complete the installation process.
When the installation is complete, the Cyclone III Development Kit installation
program creates the directory structure shown in Figure 3–1, where <path> is the
Cyclone III Development Kit installation directory.
Figure 3–1. Cyclone III Development Kit Installed Directory Structure
cycloneIII_3c120_dev
documents
examples
board_design_files
The default Windows installation directory is C:\altera\
<version#>
\kits.
factory_recovery
demos
<path>
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Commentaires sur ces manuels

Pas de commentaire