Altera USB-Blaster II Manuel d'utilisateur télécharger pdf (Page 7)

Chapter 1: Setting Up the USB-Blaster II Download Cable 1–3

Installing the USB-Blaster II Driver on Windows 7/8 Systems

October 2014 Altera Corporation USB-Blaster II Download Cable

User Guide

Installing the USB-Blaster II Driver on Windows 7/8 Systems

You must have system administration (administrator) privileges to install the

USB-Blaster II download cable drivers.

The download cable drivers are included in the Quartus II software installation.

Before you begin the installation, verify that the USB-Blaster II driver is located in

your directory: \<Quartus II system directory>\drivers\usb-blaster-ii.

1. Connect the download cable to your computer’s USB port.

When plugged in for the first time, a message appears stating Device driver

software was not successfully installed.

2. From the Windows Device Manager, locate Other devices and right-click the top

USB-BlasterII.

You need to install drivers for each interface: one for the JTAG interface and one

for the System Console interface.

3. On the right-click menu, click Update Driver Software. The Update Driver

Software - USB BlasterII dialog appears.

4. Click Browse my computer for driver software to continue.

5. Click Browse… and browse to the location of the driver on your system:

\<Quartus II system directory>\drivers\usb-blaster-ii. Click OK.

6. Click Next to install the driver.

7. Click Install when asked if you want to install.

You should now have a JTAG cable showing in the Device Manager.

8. Now, install the driver for the other interface. Go back to step 2 and repeat the

process for the other USB-BlasterII device.

When you are finished, you will have added Altera USB-Blast II (JTAG interface)

under JTAG cables.

Installing the USB-Blaster II Driver on Linux Systems

For Linux, the USB-Blaster II download cable supports Red Hat Enterprise 5 and

above.

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Pas de commentaire

Altera USB-Blaster II Manuel d'utilisateur Page 7