Altera PCI Compiler Manuel d'utilisateur télécharger pdf (Page 44)

1–10 User Guide Version 11.1 Altera Corporation

PCI Compiler October 2011

Simulate the Design

This section of the walkthrough uses the following:

■ The IP toolbench-generated PCI testbench in the

c:\altera\projects\pci_project_nativelink\verilog\pci_mt64

directory

■ The IP functional simulation model generated as specified in “Step

2: Set Up Simulation” on page 1–7

■ The ModelSim

software

■ The generated NativeLink script in the project directory,

c:\altera\projects

For this walkthrough, follow these steps:

1. On the EDA Tool Option page in the Quartus II software (Too l s >

Options > EDA Tools Option), set the location of the ModelSim

executable .

1 If you are using other simulators, set the location of your

preferred EDA simulation tool executable. This is a global

setting, and needs to be done only once.

2. At the Quartus II Tcl Console, run the following command:

source pci_top_nativelink.tcl

3. On the Simulation page (Assignments > EDA Tools Settings >

Simulation), do the following:

● select ModelSim from the Too l N a me list

● select Compile test bench under NativeLink settings.

4. Perform analysis and synthesis to create the required netlist.

5. Run the simulation.

f For more information on simulation using NativeLink, refer to

Simulating Altera IP in Third-Party Simulation Tools chapter in volume 3 of

the Quartus II Handbook.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 359 360

Pas de commentaire

Altera PCI Compiler Manuel d'utilisateur Page 44