Altera IP Compiler for PCI Express Manuel d'utilisateur télécharger pdf (Page 366)

Info–6 Chapter :

Revision History

IP Compiler for PCI Express User Guide August 2014 Altera Corporation

February 2009 9.0

■ Updated Table 1–8 on page 1–11 and Table 1–9 on page 1–13. Removed

tx_swing

signal.

■ Added device support for Arria II GX in both the hard and soft IP implementations. Added

preliminary support for HardCopy III and HardCopy IV E.

■ Added support for hard IP endpoints in the SOPC Builder design flow.

■ Added PCI Express reconfiguration block for dynamic reconfiguration of configuration space

registers. Updated figures to show this block.

■ Enhanced Chapter 15, Testbench and Design Example to include default instantiation of the

RC slave module, tests for ECRC and PCI Express dynamic reconfiguration.

■ Changed Chapter 16, SOPC Builder Design Example to demonstrate use of interrupts.

■ Improved documentation of MSI.

■ Added definitions of DMA read and writes status registers in Chapter 15, Testbench and

Design Example.

■ Added the following signals to the hard IP implementation of root port and endpoint using

the MegaWizard Plug-In Manager design flow:

tx_pipemargin

tx_pipedeemph

tx_swing

(PIPE interface),

ltssm[4:0]

, and

lane_act[3:0]

(Test interface).

■ Added recommendation in “Avalon Configuration Settings” on page 3–15 that when the

Avalon Configuration selects a dynamic translation table that multiple address translation

table entries be employed to avoid updating a table entry before outstanding requests

complete.

■ Clarified that ECC support is only available in the hard IP implementation.

■ Updated Figure 4–7 on page 4–9 to show connections between the Type 0 Configuration

Space register and all virtual channels.

■ Made the following corrections to description of Chapter 3, Parameter Settings:

■ The enable rate match FIFO is available for Stratix IV GX

■ Completion timeout is available for v2.0

■ MSI-X Table BAR Indicator (BIR) value can range 1:0–5:0 depending on BAR settings

■ Changes in “Power Management Parameters” on page 3–13: L0s acceptable latency is

<= 4 μs, not < 4 μs; L1 acceptable latency is <= 64 μs, not < 64 μs, L1 exit latency

common clock is <= 64 μs, not < 64 μs, L1 exit latency separate clock is <= 64 μs, not <

64 μs

■ N_FTS controls are disabled for Stratix IV GX pending devices characterization

Date Version Changes Made SPR

1 2 ... 361 362 363 364 365 366 367 368 369 370 371 372

Commentaires sur ces manuels

Pas de commentaire

Altera IP Compiler for PCI Express Manuel d'utilisateur Page 366

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Altera IP Compiler for PCI Express