Altera Cyclone V SoC Manuel d'utilisateur Page 39

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 38
November 2013 Altera Corporation Cyclone V SoC Development Kit
User Guide
A. Programming Flash Memory
This appendix describes programming information for the following memory
devices:
Common flash interface (CFI) flash memory
Quad serial peripheral interface (quad SPI) flash memory
SD card flash memory
The Cyclone V development board’s flash memory ships preconfigured with the
parallel flash loader (PFL) option bits to support FPGA designs to be written to any of
the three locations as shown in Table A1. The PFL is disabled by default. Set SW2.3 to
ON to enable FPGA programming from CFI flash memory on power up.
1 There are several other factory software files written to flash memory to support the
Board Update Portal. These software files were created using the Nios II EDS, just as
the hardware design was created using the Quartus II software.
CFI Flash Memory
CFI Flash Memory Map
Table A1 shows the default memory contents of the 512 Mb CFI flash device.
c Altera recommends that you do not overwrite the factory hardware images unless
you are an expert with Altera tools. If you unintentionally overwrite the factory
hardware or factory software image, refer to “Restoring the CFI Flash Device to the
Factory Defaults” on page 3–6.
Programming CFI Flash Using the Quartus II Programmer
You can use the JTAG interface in Altera CPLDs to indirectly program the flash
memory device. The Altera CPLD JTAG block interfaces directly with the logic array
in a special JTAG mode. This mode brings the JTAG chain through the logic array
instead of the Altera CPLD boundary-scan cells (BSC). The PFL megafunction
provides JTAG interface logic to do the following:
Convert the JTAG stream provided by the Quartus II software.
Table A–1. Byte Address Flash Memory Map
Block Description KB Size Address Range
Unused 44711 0x0145.635C - 03FF.FFFF
User hardware 2 6872 0x00DA.0000 - 0145.635B
User hardware 1 6872 0x006E.0000 - 00D9.635B
Factory hardware 6872 0x0002.0000 - 006D.635B
PFL option bits 32 0x0001.8000 - 0001.8080
Vue de la page 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire