Altera Arria V GT FPGA Manuel d'utilisateur télécharger pdf (Page 12)

3–2 Chapter 3: Software Installation

Installing the Quartus II Subscription Edition Software

Arria V GT FPGA Development Kit November 2012 Altera Corporation

User Guide

1 Your serial number is printed on the development kit box below the bottom

bar code. The number is 10 or 11 alphanumeric characters and does not

contain hyphens. Figure 3–1 shows 3S150SPXXXX as an example serial

number.

2. Consult the Activate Products table, to determine how to proceed.

a. If the administrator listed for your product is someone other than you, skip the

remaining steps and contact your administrator to become a licensed user.

b. If the administrator listed for your product is you, proceed to step 3.

c. If the administrator listed for your product is Stocking, activate the product,

making you the administrator, and proceed to step 3.

3. Use the Create New License page to license your product for a specific user (you)

on specific computers. The Manage Computers and Manage Users pages allow

you to add users and computers not already present in the licensing system.

1 To license the Quartus II software, you need your computer’s network

interface card (NIC) ID, a number that uniquely identifies your computer.

On the computer you use to run the Quartus II software, type

ipconfig

/all

at a command prompt to determine the NIC ID. Your NIC ID is the 12-

digit hexadecimal number on the Physical Address line.

4. When licensing is complete, Altera emails a license.dat file to you. Store the file on

your computer and use the License Setup page of the Options dialog box in the

Quartus_II software to enable the software.

f For complete licensing details, refer to Altera Software Installation and Licensing Manual.

Figure 3–1. Locating Your Serial Number

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 57 58

Pas de commentaire

Altera Arria V GT FPGA Manuel d'utilisateur Page 12