Altera Stratix GX Guide de l'utilisateur Page 297

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 318
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 296
Altera Corporation B–1
January 2005
Appendix B. Ports &
Parameters
Input Ports
Table B1 lists the input ports of the Stratix
®
GX device.
Table B–1. Input Ports (Part 1 of 4)
Port Name Required Description Comments
inclk[]
See
comments
Transceiver block
transmitter PLL
reference input
clock.
Input port [NUMBER_OF_QUADS - 1..0]
wide. If you use the transmitter PLL, the
inclk[] port is required. If you set the
OPERATION_MODE parameter to TX or
DUPLEX, the inclk[] port is required.
pll_areset[]
No Asynchronous reset
for the transceiver
block transmitter
PLL. This signal
powers down the
entire transceiver
block. When placing
refclkb pins, see
Appendix C,
REFCLKB Pin
Constraints for
information about
analog reads and
refclkb pin usage
constraints.
Input port [NUMBER_OF_QUADS - 1..0]
wide.
rx_in[]
Yes Transceiver block
receiver channel
data input port.
Input port [NUMBER_OF_CHANNELS -
1..0] wide.
rx_cruclk[]
No Clock recovery unit
(CRU) for the
transceiver block
receiver PLL
reference input
clock.
Input port [NUMBER_OF_QUADS - 1..0]
wide. When you set the
OPERATION_MODE parameter to TX or
DUPLEX, the rx_cruclk[] port cannot
be used. If you use this parameter, the
transceiver block transmitter PLL cannot be
instantiated.
rx_bitslip[]
No Controls bit slipping
circuitry in the word
aligner.
Input port [NUMBER_OF_CHANNELS -
1..0] wide. If you enable the
rx_bitslip
port, the
rx_enacdet[] port cannot be
connected and the
USE_AUTO_BIT_SLIP parameter must
be set to
OFF.
Vue de la page 296
1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 317 318

Commentaires sur ces manuels

Pas de commentaire