Altera Avalon Verification IP Suite Manuel d'utilisateur Page 36

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 178
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 35
Chapter 1: Avalon-MM Master BFM 1–13
Application Program Interface
May 2011 Altera Corporation Avalon Verification IP Suite User Guide
push_command()
set_clken()
set_command_address()
set_command_arbiterlock()
set_command_byte_enable()
Prototype:
void push_command()
.
Arguments: None.
Returns:
void
.
Description: Inserts the fully populated transaction descriptor onto the pending transaction
command queue.
Prototype:
void set_clken(bit state).
Arguments:
bit state
.
Returns:
void
.
Description: Sets the assertion and deassertion of the clock enable signal.
Prototype:
void set_command_address(bit[AV_ADDRESS_W-1:0]addr)
Arguments:
addr
.
Returns:
void
.
Description: Sets the transaction address in the command descriptor.
Prototype:
void set_command_arbiterlock (bit state).
Arguments:
bit state.
Returns:
void
.
Description: Controls the assertion or deassertion of the arbiterlock interface signal. The arbiterlock
control is on the transaction boundaries and is not used when the Avalon-MM Master
BFM is operating in burst mode.
Prototype:
void set_command_byte_enable(bit[AV_NUMSYMBOLS-1:0] byte_enable, int
index)
.
Arguments:
byte_enable
.
index
.
Returns:
void
.
Description: Sets the transaction byte enable field for the cycle of the burst command descriptor
indicated by index. This field applies to both read and write operations.
Vue de la page 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 177 178

Commentaires sur ces manuels

Pas de commentaire