Altera Transceiver Signal Integrity Manuel d'utilisateur télécharger pdf (Page 13)

Chapter 3: Software Installation 3–3

Installing the USB-Blaster Driver

December 2011 Altera Corporation Transceiver Signal Integrity Development Kit,

Stratix IV GX Edition User Guide

1 Certain DLLs that are required for the demonstration application

(stratixIVGX_si_demo.exe) to function properly are not included with the

kit installation software. These needed DLLs are installed with the Quartus

II Subscription Edition software, versions 9.1, 9.1sp1, or 9.1sp2. Make sure

you successfully display the main Quartus II GUI at least once. If you don’t

want to purchase a license, you can uninstall the Quartus II software; the

demonstration application will continue to function properly.

f If you have difficulty installing the Quartus II software, refer to the Quartus II

Installation & Licensing for Windows and Linux Workstations.

Installing the USB-Blaster Driver

The Stratix IV GX transceiver signal integrity board includes integrated USB-Blaster

circuitry for FPGA programming. However, for the host computer and signal

integrity board to communicate, you must install the USB-Blaster driver on the host

computer.

To download the USB-Blaster driver, go to the Altera support site at

www.altera.com/support/software/drivers/dri-index.html.

To install it, go to www.altera.com/support/software/drivers/usb-blaster/dri-usb-

blaster-xp.html.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Pas de commentaire

Altera Transceiver Signal Integrity Manuel d'utilisateur Page 13