Altera Nios II Manuel d'utilisateur télécharger pdf (Page 14)

14 Altera Corporation

Nios II Evaluation Kit User Guide October 2005

Using the Nios II Evaluation Kit

Password: uClinux

After logging in, the Nios II Linux shell prompt (#) appears.

Enabling Network Support

If you wish to enable network support, you can do so manually or using

DHCP.

Configuring Network Support Manually

v At the Nios II Linux shell prompt, run the following command

replacing <ip address> and <netmask> with valid parameters for

your local network.

# ifconfig eth0 <ip address> netmask <netmask> r

Configuring Network Support with DHCP

To configure your IP address with DHCP, perform the following steps:

1. Run the following command:

# dhcpcd –NRY & r

2. Wait a few moments, and then run:

# ifconfig eth0 r

The output will be similar to that in Figure 3 on page 15.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Altera Nios II Manuel d'utilisateur Page 14