Altera Nios Development Board Cyclone II Edition Manuel d'utilisateur télécharger pdf (Page 38)

2–26 Reference Manual Altera Corporation

Nios Development Board Cyclone II Edition May 2007

Board Components

f For more information on the CompactFlash connector (CON3), see

www.compactflash.org and www.molex.com.

PMC Connector

(JH1 & JH2)

The PCI mezzanine card (PMC) connector, formed by JH1 and JH2,

allows Nios II systems in the FPGA to interface to daughter cards using

the standard 32-bit PMC form factor. Refer to Figure 2–11. The PMC

connector is capable of 33MHz and 66 MHz, and is configured as the PMC

host.

w Before connecting a daughter card to the PMC connector, the

FPGA must first be configured with a design that includes a

PMC interface. Damage to either the FPGA or daughter card can

result if the FPGA is not configured correctly.

The factory-programmed Nios II reference design does not include a

PMC interface.

V23 43 INPACK_n proto1_io39

Y22 44 REG_n proto1_io40

W16 32 CS1_n cf_cs_n

AE16 9 ATA_SEL_n cf_atasel_n

AD16 5 Power supply

enable

cf_power (2)

W15 26 CD1_n cf_present_n

56 (U3) 41 RESET# proto1_RESET_n (3)

Notes to Ta b le 2 – 13 :

(1) Nets proto_io16, proto_io20, and proto_io21 do not connect to CON3.

(2) The FPGA I/O pin controls a power MOSFET that supplies 5V VCC to this net.

(3) proto1_RESET_n is driven by the EPM7256AE configuration controller device

(U3).

Table 2–13. CompactFlash Pin Table (Continued)

FPGA Pin CON3 Pin Pin Function Board Net Name (1)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 63 64

Pas de commentaire

Altera Nios Development Board Cyclone II Edition Manuel d'utilisateur Page 38